Dear Typhoon HIL Team,
I am using the TMDSCNCD28P55X ControlCARD from Texas Instruments (TI) with the DSP180 Interface 1.3 board from Typhoon HIL.
The detailed documentation for the DSP180 Interface is available at:
https://www.typhoon-hil.com/documentation/typhoon-hil-hardware-manual/hil_dsp_180_interface/References/detailed_description.html
However, the pin mapping information provided in the documentation does not appear to fully match the TMDSCNCD28P55X ControlCARD, particularly for the analog output (AO) connections. It is therefore difficult for us to identify the correct connection and MCU/DSP pin mapping through the HSEC 180-pin connector.
Could you please provide the complete pin mapping between the DSP180 Interface 1.3 and the TMDSCNCD28P55X ControlCARD, including:
Analog Output (AO) channels and their corresponding DSP/MCU pins
Digital Input (DI) and Digital Output (DO) channels and their corresponding GPIOs
HSEC 180-pin connector pin numbers
Any relevant signal conditioning or scaling information
A complete pin-to-pin mapping table would be very helpful for us in configuring and using the TMDSCNCD28P55X ControlCARD with the DSP180 Interface.
Thank you for your support.
Regards,
Ajeet
