Detailed description of the HIL DSP 180 Interface is correct?

Question

Table 1. Analog signal routing in web documentation: I have problems because real experiments do not match this table. Example: AO20 is connected to connector pin 39 (A3/B9/C7) and it is not not to ADC-C5. Please, Someone could provide me a table corrected?

Answer 1

Hi Eduardo,

The pin routing on the control card (connector pin to the chip) may depend on the model of the control card you're using. I have used the DSP 180 interface with TMDSCNCD28379D card and the pin mapping was fitting. Which control card are you using?

Comments

Thank you for your soon answare. I'm using control card TMDSCNCD280049C.

---

Please. I recomend you to provide a connection table with the 180 connector pin numbered and the AO list (also AI, DI, DO) this does not depend on the card that we are using and you do not have to generate a very large documentation, because there are a lot of diferente cards. Thank you.

---

I completely agree with you. At this moment, the only workaround is for you to "manually" map the HIL pins to 180 connector pins using the data available for TMDSCNCD28379D. Then as a next step you'd map the 180 connector pins to your TMDSCNCD280049C. I forwarded this information to relevant colleagues and the documentation will be improved in the future. Cheers

---

Thank you for your answer