triangular waveform generation

Question

I am working on the level-shift PWM technique, which requires a high-frequency repeating sequence. For that, I am using a triangular wave source. However, when I set the frequency to 10 kHz, the output becomes constant instead of triangular. The waveform appears triangular only at 50 Hz, but for any frequency other than 50 Hz, it is no longer triangular.
What could be the reason for this behavior

Answer 1

Execution rate of the Triangular Wave Source component will decide the resolution of the component output. You might want to make sure that your execution rate is at least 100 times shorter than your switching period.

Even better, consider using the PWM Modulator component, to make sure you have the maximum resolution.