Scope/Capture triggering, but not showing data in Real Time mode

Question

I have a real time simulation using the Dual Active Bridge toolbox.

In the SCADA panel, I am trying to collect data from the simulation using the scope function.  When I run the simulation, the scope triggers, but never shows data.  When I use capture and force a trigger, a triger is registered as successful but I am given a blue bar and "waiting for data...." message.

This scope and capture does work in virtual HIL mode.  Do I need to enable anything for scope/capture to work in real time mode?

Answer 1

There isn't any additional enabling that should be done. This looks like a communication issue between HIL and PC.

I know it's a silly suggestion, but you can try power-cycling the HIL device and/or creating a new SCADA panel with new Capture/Scope widget, just to see if something went wrong.